How To Install Chain Link Fence Gates?

Chain link gates are composed with mainly the these components: gate post hinges, gate fork latch, bolts, sockets, chain links fabrics, gate frame, brackets and etc.

Chain links gates installation steps and tips:
First: under the instructions, make a gate framework and the first part attached on the sliding belt. Then sliding parts are assembled door frame with your hands.

Second: sliding a rod into the fence and through a coil.

Third: attach the tension band and slide the second lever into the mesh. Make sure you slide it close enough to the opposite side rail to hold the mesh taut once you attach it to the tension bands.

Fourth: unhook the strand of mesh that's near the outside second tension bar and pull it out, removing the excess mesh with pliers.

Fifth: pull the mesh along with tension band tightly while slipping the tension bar into the tension bands on the frame of the gate with pliers, if the net is not tight enough the lever to into go to the next set of loops. Unravel the excess mesh and hook the bar back into the tension bands.

Final: attach the tie line to the benchmarking of the top and bottom once the mesh is fixed in one place. A Cable line in the mesh around the hook with pliers, pulled the network cable has been slightly higher than the door frame to the network. Ensure let the tie cord around freely in the mesh around with pliers.

Tips: his metal hardware must be ready to complete. In order to switch the gates must be to the height of the ground.

Major Chain Link Gates Types:

Double Swing Gate:
Material Steel
Surfacing Galvanization with plastic-coating
Dimensions Height: 200cm, Width: 400cm
Frame: 5cm × 5cm
Vertical bars of 2.5cm × 2.5cm, welded at a distance of 10cm
Square posts with cap: 20cm × 20cm × 250cm
Hot dip galvanized coating ISO 1461

Single Swing Gate
Material Steel
Surfacing Galvanization with plastic-coating
Dimensions Height: 200cm, Width: 100cm
Frame: 4cm × 4cm
Square mesh of 5cm × 5cm, welded into the frame
Square posts with cap: 5cm × 5cm × 250cm
Hot dip galvanized coating ISO 1461

Chain Link Fences Fitted for the Gates:
Material Steel
Surfacing Galvanization with plastic-coating
Dimensions Fence height: 200cm
Panel width: 250cm
Height of posts: 250cm
Mesh: 10cm × 5cm
Hot dip galvanized coating ISO 1461

© 2013 Yudemei Chain Link Fencing Factory, All rights reserved.

Add: No.123 Weixi Street, Dezhou, China    Email: sale@chainlinkfence.org